Effect of changing groundwater levels caused by land-use changes on greenhouse gas fluxes from tropical peat lands

Monthly measurements of carbon dioxide (CO₂), methane (CH₄) and nitrous oxide (N₂O) fluxes in peat soils were carried out and compared with groundwater level over a year at four sites (drained forest, upland cassava,upland and lowland paddy fields) located in Jambi province, Indonesia. Fluxes from swamp forest soils were also measured once per year as the native state of this investigated area. Land-use change from drained forest to lowland paddy field significantly decreased the CO₂ (from 266 to 30 mg C m^–2 h^–1) and N₂O fluxes (from 25.4 to 3.8 g N m^–2 h^–1), but increased the CH₄ flux (from 0.1 to 4.2 mg C m^–2 h^–1) in the soils. Change from drained forest to cassava field significantly increased N₂O flux (from 25.4 to 62.2 g N m^–2 h^–1), but had no significant influence on CO₂ (from 266 to 200 mg C m^–2 h^–1) and CH₄ fluxes (from 0.1 to 0.3 mg C m^–2 h^–1) in the soils. Averaged CO₂ fluxes in the swamp forests (94 mg C m^–2 h^–1) were estimated to be one-third of that in the drained forest. Groundwater levels of drained forest and upland crop fields had been lowered by drainage ditches while swamp forest and lowland paddy field were flooded, although groundwater levels were also affected by precipitation. Groundwater levels were negatively related to CO₂ flux but positively related to CH₄ flux at all investigation sites. The peak of the N₂O flux was observed at –20 cm of groundwater level. Lowering the groundwater level by 10 cm from the soil surface resulted in a 50 increase in CO₂ emission (from 109.1 to 162.4 mg C m^–2 h^–1) and a 25% decrease in CH₄ emission (from 0.440 to 0.325 mg C m^–2 h^–1) in this study. These results suggest that lowering of groundwater level by the drainage ditches in the peat lands contributes to global warming and devastation of fields. Swamp forest was probably the best land-use management in peat lands to suppress the carbon loss and greenhouse gas emission. Lowland paddy field was a better agricultural system in the peat lands in terms of C sequestration and greenhouse gas emission. Carbon loss from lowland paddy field was one-eighth of that of the other upland crop systems, although the Global Warming Potential was almost the same level as that of the other upland crop systems because of CH₄ emission through rice plants.     

Development of a high‐resolution RGBW flexible display using a white organic light‐emitting diode with microcavity structure and that of a side‐roll touch panel

In this study, white organic electroluminescent devices with microcavity structures were developed. A flexible high‐resolution active‐matrix organic light‐emitting diode display with low power consumption using red, green, blue, and white sub‐pixels formed by a color‐filter method was fabricated. In addition, a side‐roll touch display was developed in combination with a capacitive flexible touch screen.     

Association and physical gelation of ABA triblock copolymer in selective solvent

Association behavior and physical gelation mechanism of ABA triblock copolymer dissolved in B-selective solvent have been studied systematically from dilute to moderately concentrated solutions. Static and dynamic light scattering and nuclear magnetic resonance measurements for dilute solutions of poly(methyl methacrylate)-block-poly(tert-butyl acrylate)-block-poly(methyl methacrylate) (PMMA-PtBuA-PMMA) in 1-butanol (PtBuA selective solvent) indicated that PMMA-PtBuA-PMMA chains are molecularly dissolved above 50 °C. With decreasing temperature, the triblock copolymers form associated micelles consisting PMMA associated core and PtBuA shell. Linear dynamic viscoelastic measurements for solutions with moderate concentration (3.9-12.0 wt%) revealed that the system was viscous sol state at 60 °C. Drastic increase of shear storage modulus (G′) occurred with decreasing temperature, and at 25 °C, G′ showed rubbery plateau with weak frequency dependency, means the formation of elastic physical gel. The consistency between the temperature for micelle formation and that at the increase in G′ indicates that the physical gelation is owing to the network formation as the result of the association of PMMA chains and the bridging PtBuA chains connecting the PMMA cores. Master curves for the dynamic moduli were derived by time-temperature superposition along the frequency axis. Just above sol-gel transition concentration (C_gel), the master curves suggest the existence of fairy amount of aggregate that is not incorporated in the macroscopic network. With the increase in polymer concentration, the master curves become to reveal Maxwell-type viscoelasticity with narrow relaxation time distribution, suggesting the formation of transient network with easily generation and destruction of crosslinks. Concentration dependency of the plateau modulus is stronger than the theoretically expected, means the macroscopic transient network grows with polymer concentration by increasing the fraction of elastically effective bridging PtBuA chain above C_gel.     

Application of the Solvothermal Process in the Synthesis of High-performance Ag/γ-Al_2O_3 Catalysts

1 INTRODUCTION Since Cu-ZSM-5 was reported as an effective catalyst for the selective catalytic reduction (SCR) of NO by hydrocarbons in the presence of excess oxygen, the SCR of NOx has received much attention as a kind of potential technology for cleaning NOx in various oxygen-rich exhausts of diesel engine, lean burning gasoline engine and gas engine. Although a number of catalysts have been tested, to date, it still seems to be difficult to find a catalyst that is completely suit…     

Simple method of determining plasma impedance of streamer discharge in atmospheric air

For atmospheric streamer discharges using a lightning impulse generator, we demonstrate a method of determining the plasma impedance in a streamer region by analyzing the periodic attenuated discharge waveforms having high-frequency components. When the streamer region in the plasma can be treated as an equivalent series circuit model including resistance and inductance elements, the regression waveforms obtained by reducing and smoothing the discharge waveforms are analyzed in the equivalent circuit. We found that the streamer resistance increased exponentially with time after the discharge, whereas the streamer inductance and series impedance were constant at 4.0 Ω for longer than the first period of the discharge waveforms. Moreover, the slope of the regression curve increases more rapidly for the positive streamer resistance than for the negative resistance. Finally, the absolute values of the streamer impedance versus time were 3.3-19 Ω and 3.5-9.0 Ω for positive and negative discharges, respectively.     

A parallel method for large sparse generalized eigenvalue problems using a GridRPC system

In this paper we present a master–worker type parallel method for finding several eigenvalues and eigenvectors of a generalized eigenvalue problem , where A and B are large sparse matrices. A moment-based method that finds all of the eigenvalues that lie inside a given domain is used. In this method, a small matrix pencil that has only the desired eigenvalues is derived by solving large sparse systems of linear equations constructed from A and B. Since these equations can be solved independently, we solve them on remote servers in parallel. This approach is suitable for master–worker programming models. We have implemented and tested the proposed method in a grid environment using a grid RPC (remote procedure call) system called OmniRPC. The performance of the method on PC clusters that were used over a wide-area network was evaluated.     

The Visual Computing of Projector‐Camera Systems

This article focuses on real‐time image correction techniques that enable projector‐camera systems to display images onto screens that are not optimized for projections, such as geometrically complex, coloured and textured surfaces. It reviews hardware‐accelerated methods like pixel‐precise geometric warping, radiometric compensation, multi‐focal projection and the correction of general light modulation effects. Online and offline calibration as well as invisible coding methods are explained. Novel attempts in super‐resolution, high‐dynamic range and high‐speed projection are discussed. These techniques open a variety of new applications for projection displays. Some of them will also be presented in this report.     

Transflective IPS‐LCD with improved reflective contrast ratio

Abstract— In order to improve the reflective contrast ratio of transflective IPS‐LCDs, a novel pixel design for a normally white reflective IPS has been proposed. In this design, the large‐inter‐electrode‐spacing layout using a novel driving method and a double‐layered electrode have effectively reduced the light leakage. By applying these two technologies, a transflective IPS‐LCD has been successfully demonstrated with a high contrast ratio (15:1) in the reflective mode and a wide‐viewing‐angle characteristic in the transmissive mode.